Terminaux S1F2 Mode Comptoir

  
 https://scribehow.com/viewer/Setting_Up_The_S1F2_on_Counter_Mode__q9m97rQlSI-09oul8UxN3A 
   
   
   
   
 a completer** 
 
  The S1F2 terminal is our wireless solution. This terminal can be set up on both counter service and Tableside simultaneously. 
 
 Before attempting to setup the S1F2, fully charge the battery. This can take 3-4 hours for the initial charging 
   
 2. On the backside of the terminal, you will see a sticker that notes down the serial number of the terminal. This will be the terminal identifier when reaching out to support. 
   
 
 3. On the left hand side of the terminal, there is a rubber flap covering the charging port. If not charging on the doc, the terminal can be charged using the USB-C port. 
   
 4. To connect the terminal to the internet, click the settings button in the bottom left corner. You will be brought to a menu where you can select "Network" . Enter the admin pin 1234, and select "Wi-Fi" 
   
 5. You'll be brought to a list of networks. Select the network your POS is using, and enter in the password using the on-screen keyboard that appears. The network will appear at the top of the list with "Connected" underneath once properly on the network. 
 
 6. Now we need to note down the IP of the terminal. Click on the triangle in the bottom left until you are back in the Terminal Menu. From here select "Device Info" to find the IP.